Leishmania IgG/IgM Rapid Test
INTENDED USE
The Leishmania IgG/IgM Rapid Test is a rapid chromatographic immunoassay for the qualitative detection of IgG and IgM antibodies to Leishmania donovani in human whole blood, serum or plasma specimen.
MATERIALS
Materials Provided
· Individually packed test devices · Disposable pipettes |
· Package insert · Buffer |
Materials Required but Not provided
· Specimen collection container · Centrifuge · Micropipette |
· Timer · Lancets |
PROCEDURE
Allow the test device, specimen, buffer, and/or controls to reach room temperature (1530°C) prior to testing.
- 1. Bring the pouch to room temperature before opening. Remove the test device from the sealed pouch and use it as soon as possible.
- 2. Place the test device on a clean and level surface.
For Serum or Plasma Specimens:
Hold the dropper vertically, draw the specimen up to the Fill Line (approximately 10 uL), and transfer the specimen to the specimen well (S) of the test device, then add 2 drops of buffer (approximately 80 mL) and start the timer. See illustration below. Avoid trapping air bubbles in the specimen well (S).
For Whole Blood (Venipuncture/Fingerstick) Specimens:
To use a dropper: Hold the dropper vertically, draw the specimen 0.5-1 cm above the Fill Line, and transfer 2 drops of whole blood (approximately 20 µL) to the specimen well (S) of the test device, then add 2 drops of buffer (approximately 80 uL) and start the timer. See illustration below.
To use a micropipette: Pipette and dispense 20 µL of whole blood to the specimen well (S) of the test device, then add 2 drops of buffer (approximately 80 µL) and start the timer.
- 3. Wait for the colored line(s) to appear. Read results at 10 minutes.Do not interpret the result after 20 minutes.
-
INTERPRETATION OF RESULTS
LIMITATIONS OF THE TEST
- 1. The Leishmania IgG/IgM Rapid Test is for in vitro diagnostic use only. The test should be used for the detection of Leishmania antibodies in whole blood, serum or plasma specimens only. Neither the quantitative value nor the rate of increase in Leishmania antibody concentration can be determined by this qualitative test.
- 2. The Leishmania IgG/IgM Rapid Testwill only indicate the presence of Leishmania antibodies in the specimen and should not be used as the sole criteria for the diagnosis of Leishmania.
- 3. The continued presence or absence of antibodies cannot be used to determine the success or failure of therapy.
- 4. Results from immunosuppressed patients should be interpreted with caution.
- 5. As with all diagnostic tests, all results must be interpreted together with other clinical information available to the physician.
6. If the test result is negative and clinical symptoms persist, additional testing using other clinical methods is recommended. A negative result does not at any time preclude the possibility of Leishmania infection.